Avaya XT Series - Connecting a Computer to the Avaya XT Series Using the HD1 Port

Related links
Presenting Content from Your Computer on page 74
Connecting a Computer to the Avaya XT Series using the HD1
port
About this task
Instead of using the DVI port, you can use HD1 input for presentation content while using HD2 for
a live camera. If you use HD1 for the presentation content, you can display a resolution up to 4K
Full HD. In this scenario, you must connect the first camera to the HD2 port of the XT Codec Unit
and connect the cable for serial control and power to the horizontal connect (VISCA port). You
must connect the computer displaying the presentation to the HD1 port. An HDMI cable or adapter
is needed. HD2 is automatically configured for the default live camera and audio is disabled for
that port.
Procedure
1. Connect the first camera to the HD2 port and connect the cable for serial control and
power to the horizontal connect (VISCA port).
2. Connect the computer displaying the presentation to the HD1 port.
Figure 33: XT7100 with 4K Input for Presentation Content
3. Set the computer's resolution by accessing the operating system graphics settings.
4. Select your screen resolution and refresh rates from the list of supported settings. For
more information, see Table 10: Supported computer monitor resolutions and refresh
rates on page 80.
Table 10: Supported computer monitor resolutions and refresh rates
Name Resolution Digitial Refresh Rate (Hz)
(YCbCr 4:2:2; RGB formats not
supported)
3840 x 2160 30, 25, 24
Table continues…
Participating in Meetings
March 2021 User Guide for Avaya XT Series 80
Comments on this document? infodev@avaya.com