41
2.6 Network Setting
Select type of IP mode, setup the IP address of NVR/DVR, and configure the DDNS.
1. Click Setup tab > System Setting; click + to expand list of System Setting and click
Networking.
2. MAC Address: Displays the MAC address of Ethernet port on LAN card.
3. Select the IP mode – Static IP, DHCP, PPPOE.
Static IP: Assign a fixed IP address for NVR/DVR server
- IP ADDRESS: Assign a constant IP address which a real IP addresses given from
ISP.
Do Not assign the NVR/DVR server to 1.0.0.0 network segment. It might caused
the NVR/DVR cannot access to Internet due to the un-recognize to 1.0.0.0 IP
segment.
- Mask: It is a bitmask used to identify the sub network and how many bits provide
room for host addresses. Enter the subnet mask of the IP address which user has
assigned to NVR/DVR system.
To Next Page
Loading...
