AVer E1000 Series - Setup PTZ Function

79
 Setup PTZ function
Setup IP Camera PTZ Function
User can enable PTZ function if the IP camera has supported.
1. In Camera Management dialog box , click Setup tab
2. Then, select Camera # > PTZ tab.
3. In PTZ setup page, mark Use PTZ to enable PTZ function.
4. Preset Setting: use the control panel to adjust the position of the camera and select the
Preset Number to assign a number for the camera preset position. After is done, click
Save to keep the settings.
5. DwellTime: For how long the camera stays in that position before it moves to the next one
Use the direction
buttons to adjust the
lens of camera to
desire position.
Use these 2 buttons
to Zoom in/Zoom out
the lens.
Use these 2 buttons
to Focus in/ Focus
out the lens.
Direction buttons’ moving speed