AVer EH1000H-4 Nano - 1.6 Familiarizing the Remote Control Buttons

15
1.6 Familiarizing the Remote Control Buttons
Use the Remote control to operate the DVR unit.
Name
Function
(1)
Switch to playback mode
(2)
Start/stop recording video. To stop recording, the
authentication password is required.
(3)
To call out system setup menu.
(4)
To rewind the recorded video.
(5)
To start playback.
To pause playback.
(6)
To playback video at faster speed (1x ~ 32x).
(7)
To select the time and date of playback file.
(8)
Set a playing recorded video from A point to B point segment
and repeat playing on surveillance screen
(9)
To backup recorded video file to USB pen drive.
(10)
To reset alarm status.
(11)
Switch to Emap mode.
(12)
Call out PTZ control panel. Press again will close the
PTZ control panel.
Name
Function
(13)
Press to enable FN modes (The word “
Fn+
” will show up in the left bottom
corner on screen). To exit FN modes, press again.
+ : Switch to single screen display mode
+ : Switch to QUAD display mode
+ : Switch to 9 spilt screen display mode
+ : Switch to one single and 7 + 1 spilt screen display mode
+ : Enable/disable auto scan
+ : Switch to full screen
i
The + , , ~ don’t have any functions.