5. Turn the plate and hard disk over carefully and screw the
hard disk on the plate. If hard disk cannot match to the
screw hole, then, you may adjust the hard disk position
to match the screw hole.
6. Plug the SATA cable into SATA connector on the PC
board.
[Note]
1. SATA 5 is for DVD player.
2. SATA 4 is for e-SATA interface
3. 1
st
HDD is suggested to install on SATA 6.
4. The number of SATA connector is displayed nearby
SATA connector.
7. Plug the power cable and SATA cable into hard disk.
And then, screw the plate inside the DVR unit.
8. Plug the SATA cable into the left side hard disk.
User can leave un-plug the SATA cable of the left
side HDD for screwing plate inside the DVR more
easily later.
When user remove power cable from hard disk, please DO NOT pull the power cable straight way. Please
pull out the power cable by moving power connector to left and right side and slowly pull out the power cable
from hard disk.
To Next Page
Loading...
