Recording video to “V” USB flash drive
Locate the AverMedia “EzRecorder 130” (“ER130”) to the right of the TV.
Turn on “VIDEO SYSTEM” using to white switch on the desk.
Light on the “ER130” should show ORANGE.
Insert the “V” USB flash drive into front of the recorder.
Press the “REC” button on the “ER130” to turn on the unit.
Light on the “ER130” should show blinking GREEN during power on (about 30 seconds).
Light on the “ER130” should show GREEN when ready to record.
At start of Church service or event:
Press the “REC” button on the top of the “ER130” recorder.
Light on the “ER130” should turn to slow blinking RED while recording.
At End of Service:
To STOP recording, press the “REC” button on the top of the “ER130” recorder.
Light on the “ER130” recorder should change to rapid blinking RED while video recording
finishes.
Light on the “ER130” should change to GREEN when the recording is done.
To Release/”EJECT” the “V” USB flash drive, press the “F1” button on the “ER130” Remote
controller.
Light on the “ER130” recorder will blink GREEN once.
To turn off the “ER130” recorder:
Press the RED button on the remote control. WAIT.
-or-
Press and Hold the “REC” button on the top of the “ER130” recorder for more
than 4 seconds and WAIT.
Light on the “ER130” should change to blinking GREEN while “power off” is in progress.
With the flash drive installed, it takes about 15 seconds for full off.
(With no flash drive, it take about 7 seconds for full off.)
Wait for light to turn solid ORANGE.
Remove the “V” USB flash drive from the “ER130” recorder.
Return the “V” USB flash drive to the church office.
TTForce\2018SoundSystemUpgrade\2018ChurchHDMI\20190122HDMIOperatingProcedure.opt Page 1 of 4 5. Feb. 2019
To Next Page
Need help?
General
