03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
17
8. Tighten the fastening nut until the
threaded rod protrudes about one
millimetre out of the nut.
9. Assemble the ribbon photoelectric
switch and contact spring.
Ribbon unwinding mandrel
(type 2)
Tools
– 2.5 and 2 mm allen keys
– Size 7 and 8 socket wrenches
– Plastic hammer
Preparation for disassembling
1. Remove front and rear hood.
2. Remove cap (1).
2. Unscrew the contact spring (2).
3. Remove the ribbon end sensor (3).
How? - See paragraph Ribbon end
sensor on page 32.
4. Measure and note how deep the nut (5,
circled) and cap are screwed on to the
threaded rod.
5. Remove the securing nut (4).
Continued on the next page.
2
3
4
1
5
To Next Page
Loading...
