03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
20
Ribbon unwinding mandrel
(type 3)
Tools
– 2.5 and 2 mm allen keys
– Size 7 and 8 socket wrenches
– Plastic hammer
Preparation for disassembling
1. Remove front and rear hood.
2. Remove cap (1).
2. Unscrew the contact spring (2).
3. Remove the ribbon end sensor (3).
How? - See paragraph Ribbon end
sensor on page 32.
4. Measure and note how deep the nut (5,
circled) and cap are screwed on to the
threaded rod.
5. Remove the securing nut (4).
Continued overleaf.
1
2
3
4
5
To Next Page
Loading...
