Avery Dennison 64-Series - Removing the Complete Print Module; Construction of the Print Module; Disassembly of the Print Module

03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
33
Removing the complete
print module
Construction of the print module
The following components are mounted on the
cast plate (1) of the print module (2):
– Feed unit
– Material guide
– Ribbon unwinding unit
– Ribbon take-up
– Ribbon transport
– Other integral components.

The print module can be completely
removed from the printer!
Disassembly of the print module
1. Remove the rear hood.
 How to? – See chapter “Rear Hood”.
2. Remove the print head (3).
 How to? – See chapter “Print Head”.
3. Remove the contact spring (4) (Phillips
screwdriver).
 Continued on the next page.
1
2
3
4