03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
5
Factory settings
All parameters are preset ex works to values specific to each device type.
These factory settings can be restored at all times with the parameter
SPECIAL FUNCTION > Factory settings.
Default values Precondition: The parameter SPECIAL FUNCTION > Default values is set to
"standard". Is the parameter set to "User defined", those values will be
recovered, which had been set at the time, "User defined" was selected.
More detailed information about factory settings can be found in the subject
section "Info Printouts and Parameters", parameter SPECIAL FUNCTION >
Factory settings.
Service data
The status printout "Service Status" lists the printers most important service
data. Some of the counters on it, e.g. the covered distance of the printhead,
are increased automatically, others, e.g. the number of exchanged
printheads, must be increased manually by the service technician. This
happens by calling the appropriate parameter (Tab. 2).
For information on the status printout see topic section "Info-printouts and
parameters", paragraph "PRINT INFO/ Service status".
Find the service parameters in topic section "Info-printouts and
parameters", paragraph "SERVICE FUNCTION".
Menu Parameter Call in order to
Service
Increase the counter "Service
operations"
Head exchange Increase the counter "Head number"
Roller exchange Increase the counter "Roller number"
Cutter exchange Increase the counter "Cutter number"
SERVICE
FUNCTION
Serv. data reset Reset all counters to their initial value
Tab. 2 Those parameters increase the corresponding counters on the info-printout
"Service Status".
To Next Page
Loading...
