Avery Dennison 64-Series - Applying memory cards; Inserting a memory card; Removing a memory card

12/14 Rev. 03 USER MANUAL Commissioning & Operation
64-xx
17
Applying memory cards
The printer of the 64-xx series support the following memory card types:
• CompactFlash (CF) Typ I [12]
• SD [13]
1
• SDHC
Flawless functioning of the memory cards is only guaranteed for the types
distributed by Avery Dennison:
[12] CF card (article no. A7681).
[13] SD card (article no. A101465).
 Applying CF/SD cards: see Plugin-card manual, topic section „Application“,
chapter „CF/SD cards“.
Inserting a memory
card
1. Switch off the printer. Wait for 5 seconds.
2. Insert the memory card [14A,B] with the labelled side facing to the right and
the contacts facing ahead into the card slot until it clicks into place.
Removing a
memory card
CF card:
1. Switch off the printer. Wait for 5 seconds.
2. Press the eject button slightly in a bit and release it.
The eject button pops out.
3. Press the now protruding eject button completely in to eject the memory
card. Remove the memory card.
1) SD and SDHC cards are supported with firmware version 6.35 or above.
CAUTION! - Observe the following guidelines to avoid damaging the printer
or the CF card.
 Only use CF -cards approved by the manufacturer.
 Always wait at least 5seconds after switching off the printer before remo-
ving or inserting the CF card.
 When inserting or removing the CF card, never use force.
Wide guide notch
Slim guide notch
Contacts