Avery Dennison 64-Series - Setting up

03/13 Rev. 5.08-01 USER MANUAL
64-xx – 64-xx dispenser
Setting up
Winding diagrams ......................................... 2
64-xx ......................................................... 2
Designation of parts .................................. 2
64-xx dispenser ......................................... 3
Designation of parts .................................. 3
Selecting ribbon/material .............................. 4
Label material ............................................ 4
Thermotransfer ribbon ............................... 4
Inserting material .......................................... 5
Inserting fan-folded material ......................... 8
Changing material ......................................... 9
64-xx ......................................................... 9
64-xx dispenser ......................................... 9
Inserting ribbon ........................................... 10
Material / Ribbon end ..................................11
Material end .............................................11
Ribbon end ..............................................11
Rewinder full ............................................11
Settings for all printers .................................12
Ribbon tension .........................................12
Material light barrier .................................13
Print head contact pressure .....................14
Adjusting the position of the print head ....15
Material parameters .................................16
Settings at 64-xx dispensers .......................17
Dispenser types .......................................17
Basic settings ...........................................17
Parameter settings for
„64-xx dispenser M“ .................................18
Parameters settings for
„64-xx dispenser A“ ..................................18
Index ............................................................19