03/13 Rev. 5.08-01 USER MANUAL Einrichten
64-xx – 64-xx dispenser
7
Continued on next page.
14. Guide the backing paper around the feed
roller (1) and guide pins (2) of the drawing
module to form an S shape (Fig. 1).
15. Put the drawing module back in again
(Fig. 2).
On insertion, it is essential
that the locking lever points to
the right (= half a revolution
open). Do not lock it until the
drawing module has been pushed in all the
way to the limit stop!
16. Wind the end of the backing paper clock-
wise around the rewinder (3) and fix with
the clip (4) (Figs. 3 and 4).
17. Position the block bearing the pressure
roller (5) in the middle of the backing
paper.
This is important for proper transport of
the backing paper around the dispensing
edge!
18. Lock the locking lever (Fig. 4).
To Next Page
Loading...
