Avery Dennison ADTP1 - Defining the Graphic Field

5-12 Packet Reference Manual
Defining the Graphic Field
The graphic field in a format references the graphic image by the graphID in the graphic header.
This field is required only if the graphic will be stored in RAM.
Syntax G,graphID,row,col,mode,rotation |
G1. G Graphic Field.
G2. graphID Unique number from 1 to 999 to identify the graphic image. 1 is
the default.
G3. row Distance between the bottom of the print area on the supply to
the bottom of the graphic image. 10 is the default. Measured in
selected units.
English 0 – 1599
Metric 0 – 4063
203 Dots 0 – 3247
300 Dots 0 – 3599
The row specified in the constant text, bitmap, line, or box field is
added to the row value above to determine the actual position in
the format.
G4. column Distance between the left edge of the print area on the supply
and the left edge of the graphic. 10 is the default.Measured in
selected units. The column specified in the constant text,
bitmap, line, or box field is added to the col value above to
determine the actual position in the format.
English 0 – 409
Metric 0 – 1039
203 Dots 0 – 831
300 Dots 0 – 1247
G5. mode Imaging mode. Enter 0.
G6. rotation The orientation of the graphic on the supply. Enter 0.
Example G,57,0,0,0,0 |
Defines a graphic field that is identified by the number 57. The image begins at 0,0. The imaging
mode is 0 and there is no rotation.
Sample Bitmap Graphic Image
The following format shows the wire hex graphic packet included.
{F,2,A,R,E,400,400,"FMT2" |
G,99,227,35,0,0 |
Q,240,15,300,125,10," " |
T,1,5,V,285,137,0,10,2,2,B,L,0,0,0 |
T,2,5,V,255,137,0,10,2,2,B,L,0,0,0 |
T,3,15,V,180,25,0,10,1,2,B,L,0,0,0 |
T,4,15,V,121,35,0,1,3,1,B,L,0,0,0 |
L,S,94,15,94,235,10,"" |
B,5,12,F,50,65,1,2,40,1,L,0 | }
Sample Batch Packet
{B,2,N,1 |
1,"Pat’s" |
2,"Parts" |
3,"3/8 inch Wire" |
Reference to the graphic packet
4,"3.55/8 Pack" |
5,"345911871209" | }