09/09 Rev. 5.03-01 USER / SERVICE MANUAL Specifications
AP4.4 – AP5.4
10
You can find detailed information on the interfaces in the Service Handbook,
under the “Service Electronics” heading in the section on “CPU Boards”, “Plug
Connectors”.
Electronic Configuration
Specifications only for AP5.4 dispenser /
AP5.4 Internal rewinder
• Speed, while the rewinding-Ø is calculated: 75mm/s (3“/s)
• Speed, while the material is fed back: 75mm/s (3“/s)
• Distance dispensing edge - print zero line: 25mm
• Distance punch sensor - print zero line: 71mm
• Max. admissible outer diameter of the rewound backing paper roll: 120mm
Environmental Conditions
Operating Temperature 4 to 38°C
Storage Temp. -4 to 60°C
Relative Humidity 30-85% (non-condensing)
Protection category IP 21
Noise 70dB(A)
Characteristic AP5.4 AP4.4 AP4.4 RoHS
a)
a) RoHS conform printer - is built approx. from 08/2006 on.
Processor 32-bit IDT with 32-bit data bus
SDRAM 16MB 8MB 16MB
ROM 4MB Flash 2MB Flash 4 MB Flash
Plug-in Cards
A slot for Compact
Flash cards of type T1
with up to 64MB
-- --
Real-time Clock
Present; printout of date
and time possible
-- --
Control Panel
4 buttons; LCD graphics display with 122x32 pixels; typi-
cally used to display two text lines with 16 characters each.
[Tab. 7] Electronic Configuration
To Next Page
Loading...
