09/09 Rev. 5.03-01 USER / SERVICE MANUAL Specifications
AP4.4 – AP5.4
3
Options
The optional features – with the exception of the foot switch – can only be in-
tegrated into the AP5.4.
Internal Options …should be factory-fitted or installed by a service engineer:
• Reflex Sensor Kit: Light barrier fitting that apart from the transmission sen-
sor, also contains a reflex sensor.
• Label sensor for short labels. Recommended for label length < 30mm.
• Internal rewinder kit: To retrofit the internal rewinder; contains the rewinder
as well as the driver board and material guide
• I/O board: RS-422/485 interface, signal interface
• Contact brush for narrow label web (< 30mm); recommended for AP5.4
with „Rewinder 2000“.
External Options …do not require any special alterations to the printer, however, the printer
must be prepared for the use of peripheral devices:
• Cutter
• Rewinder for material rolls with 38mm (1.5”), 75 mm (3”) or 100 mm (4”)
cores („Rewinder 2000“)
• Keyboard for offline operation
• Foot switch for foot-operated label dispensing (printer must additionally be
equipped with an I/O board)
• Dispensing edge (only for dispensing versions)
To Next Page
Loading...
