Avery Dennison AP5.4 Gen II - Print Direction

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP5.4 Gen II – AP5.6
29
Print direction
AP5.4 AP5.6
[9] Orientation of the printout „Foot first“ (A) or „Head first“ (B).
Foot first (Default) Orientation of the printout according to [10A].
Head first Orientation of the printout according to [10B]. Mind the following:
¯ Define the „true“ label length (without gap length) in parameter
PRINT PARAMETERS > Material length. If the label gap is wider than 5mm, the
parameter
SYSTEM PARAMETERS > Miss. label tol. must be set to a value more than
zero.
¯ The distance between material base line and the first printable dot is
1mm. To keep this distance while printing „head first“, the material width
must be calculated as follows::
, with
b
Mat
: Material width
b
Bp
: Backing paper width
AB
Printer
Printout
b
Mat
b
Bp
2mm–=