03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP5.4 Gen II – AP5.6
44
> USB
USB select
AP5.4 AP5.6
External Device (Default setting) Setting for the connection of an USB device (e. g. USB-
Stick).
Internal Device Setting for the use of the USB port for internal communication (as device).
Internal Host Setting for the use of the USB port for internal communication (as host).
> NETWORK PARAM.
IP addressassign
AP5.4 AP5.6
¯ A change of this parameter setting forces a printer restart.
Fixed IP address This setting activates the parameters "Net mask" and "Gateway address"
(see below).
DHCP IP address is assigned automatically. The assigned IP address is displayed
for a moment on the printer display, while the printer is starting.
IP address
AP5.4 AP5.6
xxx.xxx.xxx.xxx Setting range per xxx value: 0 to 255
Change between the digits by pressing the Cut or Feed button; Acknowledge
the setting by pressing the Online button. After a change of the IP address,
the printer will reset automatically.
Net mask
AP5.4 AP5.6
xxx.xxx.xxx.xxx Setting range per xxx value: 0 to 255
Depending on the set IP address appears a default value.
¯ We recommend to use the default value!
To Next Page
Loading...
