Avery Dennison AP5.4 Gen II - Sens. Punch-LS; Foil Mode; Turn-On Mode; Error Reprint

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP5.4 Gen II – AP5.6
55
Sens. punch-LS
AP5.4 AP5.6
Sensitivity punch light sensor
Sets the sensitivity of the material photoelectric switch.
xxx% Setting range: 10 to 100%; Unit interval: 10%
Default setting: 50%
Maximum sensitivity: 100%. for narrow gaps (perforations).
Minimum sensitivity: 1%. for clearly detectable gaps.
¯ Too high a level of sensitivity can lead to gaps being detected which do
not even exist (on proofs, material thickness fluctuations, perforations etc.).
Foil mode
AP5.4 AP5.6
Thermo transfer Thermo transfer printing (Ribbon sensor activated)
Thermal printing Thermo direct printing (Ribbon sensor deactivated)
Turn-on mode
AP5.4 AP5.6
Operating mode of the printer after it has been switched on.
Online Printer starts in on-line mode.
Offline Printer starts in off-line mode.
Standalone Printer starts in standalone mode.
Error reprint
AP5.4 AP5.6
If an error occurs while a label is printed, the last printed label will normally
be reprinted. In case of label layouts containing variable data like e.g. count
fields, switching off the reprint function possibly makes sense.
Enabled Reprint in error cases (default setting)
Disabled No reprint in error cases.