Avery Dennison AP5.4 Gen II - Dispenser Parameters; Dispense Mode and Position

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP5.4 Gen II – AP5.6
70
DISPENSER PARA
¯ This menu appears only in AP5.4/5.6, and only, if SYSTEM PARAMETER >
Periph. device is set to „Dispenser“.
Dispense Mode
AP5.4 AP 5.6
¯ Only if SYSTEM PARAMETER > Periph. device = „Dispenser“.
Governs the run of the print-dispense procedure.
¯ The ribbon autoeconomy function can only be used in "Real 1:1 Mode"!
Normal 1:1 Mode y The printer cannot print on the whole label surface. A stripe at the label
beginning stays unprinted.
y The label is being dispensed while printing.
y The output volume is at its maximum level.
¯ The width of the unprintable stripe is calculated as follows:
Distance print line to dispensing edge (25mm) + Dispense position
P Also refer to parameter PRINT PARAMETERS > Dispense position.
P A graphic can be found under PRINT PARAMETERS > Cut mode > Normal 1:1 mode.
[15] The size of the not imprintable area in Normal 1:1 depends of the setting of parameter
"SYSTEM PARAMETERS > Dispense Position".
a
b
c
Label
Backing paper
Printing
Printhead
Dispensing
Edge
Feed
Direction
Non-printable area with
Dispense
Dispense
a) Dispense position = 0
b) position < 0
c) position > 0
Z0137E.eps