Avery Dennison AP5.4 Gen II - Start Cur. Len; Pullback Current; Back Diameter; Brake Current

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP5.4 Gen II – AP5.6
79
Start cur. len.
AP5.4 AP 5.6
¯ Only in production mode.
¯ Only if SYSTEM PARAMETER > Periph. device = „Intern Rewinder“.
P See parameter Start cur. len.  on page 118.
Pullback current
AP5.4 AP 5.6
¯ Only in production mode.
¯ Only if SYSTEM PARAMETER > Periph. device = „Intern Rewinder“.
P See parameter Pullback current  on page 118.
Back diameter
AP5.4 AP 5.6
¯ Only in production mode.
¯ Only if SYSTEM PARAMETER > Periph. device = „Intern Rewinder“.
P See parameter Back diameter  on page 119.
Brake current
AP5.4 AP 5.6
¯ Only in production mode.
¯ Only if SYSTEM PARAMETER > Periph. device = „Intern Rewinder“.
P See parameter Brake current  on page 119.
Break diameter
AP5.4 AP 5.6
¯ Only in production mode.
¯ Only if SYSTEM PARAMETER > Periph. device = „Intern Rewinder“.
P See parameter Brake diameter  on page 119.