Avery Dennison AP5.4 Gen II - Delimiter Char; Label Top; Left Position; Manual Calibrate

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP5.4 Gen II – AP5.6
81
Delimiter Char
AP5.4 AP5.6
Used as a parameter place marker in MLI format instructions.
xxH Default: xx = 2C (0x2C = „Comma“)
Label Top
AP5.4 AP5.6
Label top offset (y-offet) in dots. Equals the parameter PRINT PARAMETERS >
Y-Printadjust
, which will be ignored, when MLI printjobs are printed.
xxx Dots Setting range: -240 - +240; Default: 0; Step width: 1
Left Position
AP5.4 AP5.6
Left position offset (x-offset) in dots. Equals the parameter PRINT PARAMETERS >
X-Printadjust
, which will be ignored, when MLI printjobs are printed.
xxx Dots Setting range: -9999 - +9999; Default: 0; Step width: 1
Manual Calibrate
AP5.4 AP5.6
For endless material, the label length information is sent in the printjob. For
punched material, the label length has to be detected by activating this func-
tion.
YES Label length calculation for punched material.
¯ Activate this function, if label material has changed.
¯ Calibration should be done after changing material, when there are no
printjobs loaded in the printer.
¯ Shortcut (in offline mode): press the feed + prog buttons simultaneously
to activate the calibration.
Resolution
AP5.4 AP5.6
Print resolution in dpi. A 200dpi graphic printjob can be printed with a 300 dpi
printhead.
xxx DPI Setting range: 200/300 dpi; Default: 300 dpi;