Avery Dennison AP5.4 Gen II - Label Invert; Command ^JM; Command ^MD;~SD

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP5.4 Gen II – AP5.6
83
Label Invert
AP5.4 AP5.6
Rotates the printout by 180°. Equals the parameter PRINT PARAMETERS >
Print direction
, which will be ignored, when MLI printjobs are printed.
[17] Orientation of the printout: Setting „Disable“ (A) or „Enable“ (B).
Disable The label is printed with „normal“ orientation [20A].
Enable The label printout is rotated by 180° [20B].
Command ^JM
AP5.4 AP5.6
¯ Interpreter version: 1.32 or higher
The ^JM command changes the printer resolution:
y ^JMA sets the resolution to the default value = printhead resolution.
y ^JMB sets the resolution to 200dpi, if the actual resolution is 300dpi. If the
actual resolution is 200dpi, this command is ignored.
Disable The resolution setting sent in the MLI printjob is ignored.
Enable The resolution setting is not ignored.
Command ^MD/~SD
AP5.4 AP5.6
The MLI commands ^MD and ~SD (set printhead darkness value) are proc-
essed optionally.
Enable ^MD- and ~SD are processed.
Disable ^MD- and ~SD are ignored.
AB
Printer
Printout