03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP5.4 Gen II – AP5.6
86
Store Diagnosis
AP5.4 AP5.6
Stores the diagnostic data on SD-card. The default file name composes as
follows:
„Diagnose AP 5.4 203 Dpi A429403110613.log“
y AP 5.4 203 Dpi: printer type and printhead resolution
y A429403110613: serial number of the CPU board; equals the value
displayed under
SERVICE DATA > CPU board data > Serial number
P
For details read the service manual, topic section „Fault Location“, chapter
„Reading out diagnostic data“.
Data blocks del.
Delete data blocks
AP5.4 AP5.6
¯ Only appears, if at least one data block is in the flash memory.
Bxx (Default setting) After calling the parameter, data block number 01 is
displayed:
„B01“: block number 01
„diagnose inf“: name of the data block, is contained in the data block header.
If the flash memory contains more than one data block:
« Press the cut button several times, until the wanted data block appears.
Deleting a data block:
« Press the online button.
« Press the feed button to change to „yes“.
« Press the online button to delete the block.
All All data blocks contained in the flash memory are deleted.
Data blocks del.
B01 diagnose inf
Data blocks del.
Delete? --> no
To Next Page
Loading...
