03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP5.4 Gen II – AP5.6
95
Rewinder adjust
AP5.4 AP5.6
¯ Only with „Rewinder 2000“ installed.
Setting up the rewinder.
The rewinder setup compensates differeces in characteristic or assembly of
the light barrier.
¯ CAUTION! - This parameter counts for both, the external rewinder option
for AP5.4 and the backing paper rewinder of the ALX92x. But mind that the
setting values are different!
P A setting description for the rewinder option is given in the „Manual Rewinder
2000“, paragraph Adjusting the sensor .
Resting pos.xxx Setup of the resting position (xxx = actual sensor value).
End pos. xxx Setup of the End position (xxx = actual sensor value).
The setting follows in both cases this scheme:
1. Bring the dancer arm to its resting position.
2. Press the cut button
¯ Not the Online button (as with TTX x50)!
3. Bring the dancer arm to its end position.
4. Press the Online button.
Printtest
AP5.4 AP5.6
General printtest, prints line by line the set printer type and the firmware ver-
sion. Material settings (Material type, length, width) are considered.
Stop the printtest by pressing the Online button.
To Next Page
Loading...
