03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP5.4 Gen II – AP5.6
98
Head run length
AP5.4 AP5.6
Shows the total "covered distance" of the printhead. The counter is reset with
each calling of the parameter
SERVICE FUNCTION > Cutter exchange = yes. Maximum
value: 4 billions.
Roll run length
AP5.4 AP5.6
Shows the total "covered distance" of the print roller. The counter is reset with
each calling of the parameter
SERVICE FUNCTION > Roller exchange = yes. Maximum
value: 4 billions.
Cuts on knife
AP5.4 AP5.6
¯ Only with mounted and activated cutter.
Shows the number of cuts done by one knife. The counter is reset with each
calling of the parameter
SERVICE FUNCTION > Cutter exchange = yes. Maximum value:
4 billions.
Tot. mat. length
AP5.4 AP5.6
Shows the total "covered distance" of the feed roller. In comparison to the
counter Roll run length, this counter is not reset after a roller exchange. Max-
imum value: 4 billions.
Tot. foil length
AP5.4 AP5.6
Shows the total "covered distance" of the ribbon roller.
Total cuts
AP5.4 AP5.6
¯ Only with mounted and activated cutter.
Shows the number of cuts done by all knifes. In comparison to the counter
Cuts on knife, this counter is not reset after a knife exchange. Maximum val-
ue: 4 billions.
To Next Page
Loading...
