2-2 Loading Supplies & Printing
Loading Supply for Non-Peel Mode
The printer can print on thermal-direct labels and
tags. Make sure the black mark/die cut sensor is set
correctly for your supply type. See “Adjusting the
Black Mark/Die Cut Sensor,” for more information.
Note: If you run out of supply while printing, do not
turn off the printer when reloading the supply.
You may lose your data. The printer resumes
printing when reloaded.
1. Remove and discard the tape from a new roll of
supply.
2. Press the cover release levers (located on both
sides of the printer) towards the front of the
printer to release the cover.
3. Lift open the cover.
To Next Page
Loading...
