Getting Started 1-3
Connecting the Power Supply
Caution: Do not touch the electrical connectors
while setting up the printer. Electrostatic
discharge can damage or destroy the
printhead or electronic components.
To connect the power supply:
1. Place the printer in a location that allows easy
access to the front of the printer.
Note: Never operate the printer while it rests on its
side or upside down.
2. Place the power supply in a suitable location,
preferably on the floor, near an electrical outlet.
3. Turn off the printer. Press the switch on the back
of the printer to the OFF position (O).
4. Plug the three-hole end of the AC adapter cable
into the three-pronged outlet in the power supply.
5. Plug the round end of the power supply cable
(labeled “printer”) into the socket at the back of
the printer.
6. Plug the three-pronged end of the AC adapter
cable into a grounded electrical outlet.
To Next Page
Loading...
