Getting Started 1-5
For serial communication:
1. Turn off the printer before connecting the cable.
2. Connect a serial printer cable from the host to the
serial port at the back of the printer.
3. Secure the cable with the connecting screws.
The factory defaults are 9600 Baud, 8-bit data
frame, 1 stop bit, no parity, and DTR flow
control.
To set communication values, refer to the
Packet Reference Manual.
USB Port
The printer has a USB (Universal Serial Bus) Version
2.0 communication port.
USB Port
9-pin
Serial Port
To Next Page
Loading...
