1
This Quick Reference contains supply loading and general care and
maintenance procedures. For more detailed information, refer to the
Operator’s Handbook available on our Web site (www.monarch.com).
For information about creating formats or programming the printer, refer
to the Programmer’s Manual on our Web site.
Note: Information in this document supercedes information in previous
versions. Check our Web site for the latest documentation and
release information.
Connecting the Cables
The power supply automatically switches between 115V or 230V. There
are no operator settings required.
1. Plug the power cable into the socket. Plug the other end of the cable
into a grounded electrical outlet.
2. Connect the communications cable into
the appropriate port. Secure the cable
with the connecting screws (serial) or
spring clips (parallel).
If you are communicating with the host
through the serial port, make sure the
printer's communication values match
those at the host. The factory default
values are 9600 Baud, no parity, 8 bit
data frame, 1 stop bit, and DTR flow
control (9600, N, 8, 1, DTR). Set the
communication values on the printer to
match those at the host.
The printer also contains a USB
(Universal Serial Bus) Version 2.0
communications port, which is
compatible with Version 1.1. Drivers are
available on our Web site for a variety of
operating systems.
3. Turn on the printer. Press ( I ) to turn
on and ( O ) to turn off the printer.
Power cable goes here
USB Port
To Next Page
Loading...
