Cleaning the Black Mark Sensor
To clean the black mark sensor:
1. Turn off the printer and open the supply cover.
2. Remove the supplies.
3. Open the label deflector by gently pushing down on the label deflector.
4. Clean the black mark sensor with a dry cotton swab.
5. Reload the supplies, close the supply cover and the label deflector.
Black Mark
Sensor
Cleaning the Scanner Window
Clean the scanner window whenever it appears to be dirty or smeared. To clean it:
1. Turn off the printer.
2. Moisten a soft cloth with distilled water. Do not use household cleaners to clean the printer.
Scanner Window
3. Ge
ntly wipe the window until it is completely clean.
Note: Pressing too hard on the window can crack or dislodge the window.
Care & Maintenance 4-3
To Next Page
Loading...
