Avery Dennison Pathfinder 6140 - Assembling the Network Control Module; Module Preparation and End Cap Removal; Connecting the Connector Plate

2-EN
Loading Supplies
1. Push the latch buttons to open the supply cover.
2. Spread the supply holder tabs apart so it adjusts to the size of your
supply roll and lock the supply holder in place.
3. Place a roll of supply in the supply holder as shown.
4. For non-peel mode, close the supply cover, make sure the printer is
on, then press Feed.
For peel mode, continue to step 5.
Supply Holder
Supply Lock Tab
Latch
Button