Avery Dennison Pathfinder 6140 - Defining Printer Setup XML Tags; Defining the Quantity Tag (Optional); Defining the Energy Tag (Optional); Defining the Contrast Tag (Optional)

5-2 LNT Programmer’s Manual
Defining Printer Setup XML Tags
These Printer Setup tags can be defined in the <JobData> file for a single print job. Printer
settings in the <JobData> file take priority over these settings defined in the LNT file.
Defining the Quantity Tag (Optional)
The Quantity tag specifies the number of labels to print.
Valid values include: 1 to 999. The default is 1.
Syntax <Quantity>value</Quantity>
Example <Quantity>5</Quantity>
Prints 5 copies of label.
Defining the Energy Tag (Optional)
The Energy tag defines the printhead energy level. The Energy tag defines the printhead
energy level. You may need to adjust this value depending on the type of supplies you are
using. For example, synthetic supplies require the High energy setting, but standard paper
does not.
Valid values include: Normal (0) and High (1). The default is Normal.
Syntax <Energy>value</Energy>
Example <Energy>High</Energy>
Sets the printhead energy to high for synthetic supplies.
Defining the Contrast Tag (Optional)
The Contrast tag defines the print contrast for the job. You may need to adjust this value
depending on the type of supplies you are using. For example, synthetic supplies require a
higher print contrast, but standard paper requires less contrast.
Note: Solid black print should not exceed 30% on a given square inch of the label, or the
printhead life may be decreased.
Valid values include: -100% (minimum contrast) to 100% (maximum contrast). The default is
0 (no contrast adjustment).
Syntax <Contrast>value</Contrast>
Example <Contrast>35</Contrast>
Sets the print contrast to 35% for this job.