AVM FRITZ!Box Fon WLAN User Manual

Configuring Analog Equipment
42 5 Configuring FRITZ!Box Fon WLAN for Telephone Connections
5.3 Configuring Analog Equipment
FRITZ!Box Fon WLAN is configured so that you can make calls
to the analog network immediately after connecting analog
terminal devices, without any additional settings required.
The following settings are preconfigured at the analog lines
“FON 1”, “FON 2” and “FON 3”:
z calls can be accepted on all three lines: connected ter-
minal devices will ring at the same time
z outgoing calls can be conducted on all three lines
If the connected terminal devices are to react only to certain
numbers, numbers must be assigned to the extensions. The
number defined as “Number of the extension” also defines
whether calls from this extension will be conducted using
the fixed-line network or the Internet.
To do this, perform the following steps:
1. Start a web browser.
2. Enter fritz.box in the address field.
3. Select the “Settings” menu.
4. Click the “Extensions” command in the “Telephony”
menu.
5. On the “Overview” page, click the button next to the
number of the extension to change its properties.
6. If the terminal equipment is to react only to the speci-
fied number, remove the checkmark from the checkbox
“React to all numbers”.
7. Select the desired number from the “Number of the ex-
tension” drop-down menu.
The device connected to the “FON 1” extension reacts
to incoming calls placed to this number and uses the
kind of connection specified for outgoing connections
with this number.

AVM FRITZ!Box Fon WLAN Specifications

General

Brand	AVM
Model	FRITZ!Box Fon WLAN
Category	Wireless Router
Language	English