Chapter 2: Installation 13
To log into the console server through the console:
1. From a connected terminal or computer with a terminal emulator, log into the console port as
root.
ACS5000 login: root
Password: avocent
WARNING: For security reasons, it is recommended that you change the default password avocent as soon as
possible for the root and admin users. To change the default password, enter the passwd command at the
prompt and enter a new password when prompted.
To use the wiz command to configure network parameters:
1. Launch the configuration wizard by entering the
wiz command.
[root@ACS5000 root]# wiz
The system displays the configuration wizard banner and begins running the wizard.
2. At the prompt, enter
n to change the defaults.
Set to defaults (y/n)[n]: n
3. Press Enter to accept the default hostname, otherwise enter your own hostname.
Hostname [CAS]: fremont_branch_console server
4. Enter n to specify a static IP address for console server.
Do you want to use DHCP to automatically assign an IP for your system?
(y/n)[y] : n
5. Enter an IP address at the prompt.
System IP[192.168.160.10]: <console server_IP_address>
6. Enter the domain name.
Domain name[avocent.com]: <domain_name>
7. Enter the IP address for a primary DNS (domain name) server.
Primary DNS Server[192.168.44.21] : <DNS_server_IP_address>
8. Enter the IP address for the gateway.
Gateway IP[eth0] : <gateway_IP_address>
9. Enter the netmask for the subnetwork.
Network Mask[#] : <netmask>
The network configuration parameters appear.
10. Enter
y after the prompts shown in the following screen example.
Are all these parameters correct? (y/n)[n]: y
To Next Page
Loading...
