74 Cyclades ACS 5000 Installation/Administration/User Guide
a. Enter the IP address of a server in the Host to Connect field.
b. Enter the terminal type in the Terminal Type field.
c. Configure other parameters on the Other screen as needed.
5. Specify authorized users or groups (see Ports - Physical Ports - Access on page 76).
6. Click Done.
7. Click apply changes.
To configure a serial port for direct connection with Telnet or SSH [Expert]:
Perform this procedure to enable users to directly connect (with either Telnet, SSHv1 or SSHv2) to
the device that is connected to the selected serial port.
1. Select Expert - Ports - Physical Ports, select a port or ports to modify and click Modify
Selected Ports. The General screen appears.
2. Select one of the following options from the Connection Protocol pull-down menu: Telnet,
SSHv1 or SSHv2.
3. If desired, enter a name for the port in the Alias field.
4. If you wish to change any of the other current settings, see To configure serial port connection
settings to match the connected devices [Expert]: on page 75.
5. To further configure the serial port perform the following tasks:
• To configure user access and authentication, see Ports - Physical Ports - Access on page
76.
• To configure the TCP Port number and other options see Ports - Physical Ports - Other on
page 84.
6. Click Done.
7. Click apply changes.
To configure a serial port for a modem [Expert]:
This procedure assumes that the selected serial port is physically connected to a modem.
1. Select Expert - Ports - Physical Ports, select a port or ports to modify and click Modify
Selected Ports. The General screen appears.
2. Select one of the following options from the Connection Protocol pull-down menu: PPP-No
Auth., PPP, SLIP or CSLIP.
3. If you wish to change any of the other current settings, see To configure serial port connection
settings to match the connected devices [Expert]: on page 75.
4. Specify authorized users or groups (see Ports - Physical Ports - Access on page 76).
5. To specify the TCP Port number and configure modem initialization and PPP options see Ports
- Physical Ports - Other on page 84.
6. Click Done.
To Next Page
Loading...
