Chapter 6: Power Management 105
Wake Up State
(SPC and
ServerTech)
wakeup
<outlet list> [on | off | last]
Set the outlet state after a cold boot. It can be set to On,
Off or the last saved state.
[last] is for ServerTech only.
Sequence Interval seqinterval
<outlet list> [<interval>]
Set the delay time (in seconds) when turning on multiple
outlets at the same time (Valid only on a master Server
Technology Sentry CDU).
Cycle Interval
(ServerTech)
cycleinterval
<outlet list> [<interval>]
Set the time delay (in seconds) for turning on
subsequent outlets after an outlet has been turned on.
(N/A) menu Enter menu mode (from pmCommand only).
Cold Start Delay
(Avocent PM
PDU)
coldstartdelay <IPDU ID>
<duration>
Set the duration of the cold start delay for the defined
PDU or all connected PDUs when one is not defined.
Current Threshold currentthreshold <IPDU ID>
[<element>] <thresholds>]
Display or set the threshold for current of one element
Set command requires <element> argument.
The <element> can be pdu, bank name (A, B, C, XY, ...),
phase name (X, Y, Z), outlet number (1, 2, ... )
Power Off Delay
(Avocent PM
PDU)
poweroffdelay <outlet list>
<delay>
Set the time delay (in seconds) for turning off outlets.
Power Info powerinfo [reset] [<IPDU
ID>] [<element>]]
Display or clear the maximum/minimum/average power
consumption of a defined element or all elements if one
is not defined.
The <element> can be bank name (A, B, C, XY, ...),
phase name (X, Y, Z), outlet number (1, 2, ..)
Cumulative Power cumulativepower [reset]
[<IPDU ID> [<element>]]
Display or clear the cumulative power consumption of a
defined element, or all elements if one is not defined, to
zero.
The <element> can be bank name (A, B, C, XY, ...),
phase name (X, Y, Z), outlet number (1, 2, ..)
Power Factor powerfactor [reset] [<IPDU
ID> [<element>]]
Display or reset the maximum/minimum/average
recorded power factor of a defined element or all
elements if one is not defined.
The <element> can be bank name (A, B, C, XY, ...),
phase name (X, Y, Z), outlet number (1, 2, ...)
Table 6.1: pmMenu and pmCommand Commands (Continued)
Menu Item Command Syntax Description
To Next Page
Loading...
