Chapter 2: Network Configuration 11
NOTE: If services not supporting IPv6 are needed, select Dual Stack (IPv4 and IPv6) and those services will be
available for IPv4.
IPv4 Addressing
To enable IPv4 network addressing:
1. From the shell prompt on your terminal, enter the following command.
# CLI
2. From the cli prompt, enter the following:
cli> config network hostsettings ipmode dualstack
This will enable both IPv4 and IPv6 network addressing.
-or-
cli> config network hostsettings ipmode ipv4
This will enable IPv4 network addressing only.
To set IPv4 specific configurations:
From the cli prompt, enter the following.
cli> config network hostsettings
Follow the parameters in Table 2.1 for the rest of the configuration.
IPv6 addressing
Services not supported in IPv6
IPv6 does not support the following services:
• NIS authentication
• NFS data logging
Table 2.1: IPv4 Specific Configurations
IPv4 Specific Level 1 IPv4 Specific Level 2 Description
primipaddress <nnn.nnn.nnn.nnn> The primary IP address of the console server -
automatically obtained if DHCP is enabled
secipaddress <nnn.nnn.nnn.nnn> The secondary IP address of the console server
primsubnetmask <nnn.nnn.nnn.nnn> Subnet mask for the primary IP address
secsubnetmask <nnn.nnn.nnn.nnn> Subnet mask for the secondary IP address
dhcp <nnn.nnn.nnn.nnn> An IPv4 address will be dynamically obtained from a
DHCPv4 server
To Next Page
Loading...
