Avocent Cyclades ACS 5000 - Network Time Protocol (NTP)

Chapter 5: Administration 85
The following are examples of configuring timezones.
cli> config administration timezone custom acronym PDT
cli> config runconfig
cli> config savetoflash
cli> config administration timezone standard 08h_west_GMT
cli> config runconfig
cli> config savetoflash
cli> config administration timezone custom dst on dstacronym PDT
dststartday Mar/2nd/Sun dstendday Nov/1st/Sun
cli> config runconfig
cli> config savetoflash
Network Time Protocol (NTP)
The ntpclient is a Network Time Protocol client for UNIX and Linux based systems. In order for
the console server to work as an NTP client, the IP address of the NTP server must be configured.
To configure an NTP server:
1. Execute the following command to configure the NTP server IP address.
cli> config administration ntp <NTP server IP address>
2. Activate and save your configuration.
Standard 01h_east_GMT
.
.
.
14h_east_GMT
GMT
01h_west_GMT
.
.
.
12h_west_GMT
Table 5.10: Timezone Configuration Parameters (Continued)
Parameter
Level1
Parameter
Level2 Value Description