34 Cyclades ACS 6000 Advanced Console Server Installation/Administration/User Guide
2. Click the name of the network device to configure. The Settings screen appears. Use the
following table to confirm your device settings.
3. Click Save, then click Close.
Bonding
An administrator can select Appliance Settings - Network - Bonding to enable and configure
Ethernet bonding (also called failover). When bonding is enabled, the eth0 interface is used for
access, and eth1 is used if the eth0 interface fails.
To enable bonding:
1. Select Appliance Settings - Network - Bonding. The Bonding screen is displayed.
2. Click Bonding with eth0 as primary and eth1 as second mode of access to enable network
bonding.
3. Set the following values:
• Miimon - The interval (in milliseconds) at which the active interface is checked to see if it
is still communicating.
• Updelay - The time (in milliseconds) that the system waits before it makes the primary
interface active after the primary interface is detected as up.
4. Click Save, then click Close.
Table 4.1: Device Configuration Settings
Parameter Description
Status Select Enabled or Disabled from the pull-down menu.
IPv4 Method
• DHCP
•Static
• IPv4 address unconfigured
• Select DHCP to have the IPv4 IP address set by the DHCP server.
• Select Static to enter the IPv4 IP address and subnet mask
manually.
• Select IPv4 address unconfigured to disable IPv4.
IPv6 Method
• DHCP
•Static
•Stateless
• IPv6 address unconfigured
• Select DHCP to have the IPv6 IP address set by the DHCP server.
• Select Static to enter the IPv6 IP address and subnet mask from
the keyboard.
• Select Stateless if the link is restricted to the local IP address.
• Select IPv6 address unconfigured to disable IPv6.
MAC Address The MAC address for the device is displayed here.
Wireless LAN
• MyPrivateNet (ESSID)
• Channel
• Encrypted
•Key
NOTE: This parameter is active only for mounted Ethernet PC cards.
•Click MyPrivateNet (ESSID) to enter the unique identifier for the
wireless access point.
•Click Channel to enter the communication channel with the access
point.
•Click Encrypted to enable data encryption during transmission.
• Enter the key or password to decode incoming encrypted data.
To Next Page
Loading...
