52 Cyclades ACS 6000 Advanced Console Server Installation/Administration/User Guide
b. Under Power Settings, select Auto, SPC, Cyclades or ServerTech from the PDU Type
pull-down menu and enter the correct number of seconds in the Polling Rate field.
8. For port(s) connected to a modem, select Dial-in from the Serial Profile menu.
9. To reconfigure the connections settings to match the device(s) connected to the selected
port(s), make the needed changes in the Communication Settings area of the screen.
10. Click Save.
11. Click Close.
To enable and configure the auxiliary port for a connected modem or PDU:
If an internal modem is not already installed at the factory, you can connect an external modem or a
PDU to the Aux/Modem port. Perform this procedure to configure the auxiliary port.
1. Select Appliance Settings - Ports - Physical Ports - Auxiliary Ports. The Auxiliary Ports form
appears.
2. Click the port number. The Aux Ports Settings form appears.
3. Select Enabled or Disabled from the Status menu.
4. If the port is connected to a PDU, perform the following steps.
a. Select Power from the Serial Profile menu.
b. Under Power Settings, select Auto, SPC, Cyclades or ServerTech from the PDU Type
pull-down menu and enter the correct number of seconds in the Polling Rate field.
5. If the port is connected to a modem, select Dial-in from the Serial Profile menu.
6. Click Save.
7. Click Close.
CAS Profile
An administrator can select Appliance Settings - Ports - CAS Profile to configure settings for ports
that are assigned to the CAS profile. The CAS Profile option has six options shown in the following
table.
Table 7.2: CAS Profile Options
Option Description
Global Settings Configure data buffer storage
Default Settings Configure the connection protocol, authentication, auto discovery and other general
settings
Devices Configure one or more ports that have the CAS profile
Auto Discovery Configure settings and probe and match strings for ports that are configured for auto
discovery
Auto Answer Configure an auto answer input and output string
To Next Page
Loading...
