78 Cyclades ACS 6000 Advanced Console Server Installation/Administration/User Guide
NOTE: If you start another session with the console server while viewing this screen, it will not be visible until you
click Refresh at the top of the Web Manager window.
To kill an active session:
1. Click Active Sessions. The Active Sessions screen is displayed and lists all open sessions to the
console server by the user’s workstation IP.
2. Select the checkbox next to the session you want to kill, then click the Kill button.
CAUTION: It is possible to kill your own session. Be sure to know your workstation IP and session type. If you kill
your session, you will see the message “Your session has been terminated” and you will have to log in again.
3. After a few seconds, the Active Session screen will redisplay the open sessions, minus the one
you killed.
Monitoring
When you click Monitoring, a variety of network and console port information is available for
viewing. The screens are only for viewing and have no interactivity with the user. The following
table shows the types of information available.
Table 9.6: Monitoring Screens
Screen Name Definition
Network - Devices Shows Ethernet ports and PC card Device Name, Status (enabled/disabled),
IPv4 Address, IPv4 Mask and IPv6 Address.
Network - IPv4 Routing Table Shows Destination, Gateway, Genmask, Flags, Metric, Ref, Use and lface.
Network - IPv6 Routing Table Shows Destination, NextHop, Flags, Metric, Ref, Use and lface.
Serial Status Shows Device Name, Connection Name, Profile, DTR, DCD, RTS, CTS and
CAS Sessions.
Serial Statistics Shows Device Name, Speed, TX Bytes, RX Bytes, Frame Error, Parity Error,
Break and Overrun.
To Next Page
Loading...
