320_420_328_428_503_521_311_411_511_401_402_332_532_808_829_839_quick_V1.5
CABLE OVERVIEW DEFAULT VALUES
Cable Description
Power cable DC12V power supply.
RJ45 network cable* Connect it to a RJ45 cable.
GND Ground wire
Alarm-in** Reserved for external alarm device connection
Alarm-out** Reserved for external alarm device connection
RESET
Remove the insulating coating of wire, and twist it with a ground wire
together to reset default camera
Line-in** Colored as blue, used to connect to a microphone for audio input.
Line-out** Colored as green, used to connect to a speaker for audio output.
* For PoE (IEEE802.3af) installation, make sure your network cable has the maximum cable resistance of 20Ω,
such as CAT.5e or CAT.6 cables, to conform to the standard of IEEE802.3af.
** For selected models only
IP address 192.168.1.10
Port number 88
User name admin
Password admin
It's strongly recommended to change the default user name and password before using the camera to
keep your account safe.
To change the default account, log into the camera, and go to Config. General Account. Create
a new account, and remove the default one.
SYSTEM CONNECTION
1. Connect IP cameras and a monitor to the NVR, and power on the NVR, as illustrated below.
Note:
Local connection only allows monitoring locally. To monitor from anywhere other than the NVR is installed,
please connect your NVR to Internet.
2. Wait till each camera is configured automatically and you will see camera images on the monitor
soon.
Note:
Local connection only allows monitoring locally. To monitor from anywhere other than the NVR is installed,
please connect your NVR to Internet.
Type1 Type2
To Next Page
Loading...
