AVTECH Software, Inc. Page 35 AVTECH.com
Room Alert S Models (RA32S-DAP-RAS & RA12S-DAP-RAS)
the Status screen to refresh at. You may enter a value from 1 to 255. The default is
5 seconds.
• In Web Port, you may change the port number your web browser uses to connect
to your Room Alert’s web interface. By default, it uses port 80 for HTTP and port
443 for HTTPS.
• To change the web port, select the Custom Web Port checkbox above the Web
Port eld.
• Select the Enable HTTPS checkbox to enable your Room Alert to use HTTPS for its
local web interface. When enabled, your Room Alert Monitor’s local web interface is
secured by an SSL certicate issued to *.roomalertmonitor.com.
• In Temperature Scale, you may choose Fahrenheit or Celsius from the drop-down
list. Fahrenheit is the default.
Date & Time Conguration
In Date & Time Conguration, you may congure the date and time defaults for your Room
Alert.
• In Time Zone, select your time zone from the drop-down list. (GMT) Greenwich
Mean Time is the default.
• In Time Display, you may select the AM/PM or 24 hour format from the drop-down
list. The 24 hour setting is the default.
• In Time Format, you may select either the MM/DD/YY or DD/MM/YY date format
from the drop-down list. Month rst (MM/DD/YY) is the default.
• Select Enable Daylight Savings if you would like your Room Alert time setting to
compensate by +1 hour for daylight savings time.
Time Server
By default, Room Alert uses the Network Time Protocol (NTP) server, time.nist.gov. In the
Time Server sub-section, you may choose to use a custom time server.
• To use a dierent time server, select the Use custom time server checkbox.
• In Domain Name/IP, enter your time server’s domain name or IP address.
• In Auto Refresh, you may select how often Room Alert automatically synchronizes
with your time server. You may leave the default, 24 Hours, or choose another
interval, as frequent as 10 minutes, from the drop-down list.
Trace Conguration
You may congure your Room Alert for trace output, which is useful for troubleshooting.
Trace output shows the communication between your Room Alert and your mail server, as
well as other information, such as the current rmware version, IP address, MAC address,
and requests to web pages.
To Next Page
Loading...
Need help?
General
