Need help?Do you have a question about the AWID SENTINEL-SENSE MPR-2010AR and is the answer not in the manual?
General| Model | MPR-2010AR |
|---|---|
| Type | RFID Reader |
| Frequency | 902-928 MHz |
| Frequency Range | 902-928 MHz |
| Power Supply | +5 to +12 VDC |
| Operating Temperature | -22° to +150° F (-30° to +65° C) |
| Dimensions | 3.125 x 3.125 x 0.75 inches (7.9 x 7.9 x 1.9 cm) |
| Weight | 4 oz (113 g) |
| Output Power | 1W (30 dBm) |
| Interface | RS-232, Wiegand |
| Output Format | Wiegand |
Explains how the reader uses radio frequency to identify, locate, and track items with RFID transponders.
Lists key features of the MPR-2010AR reader, including multi-protocol support and performance capabilities.
Details the channel frequencies used by the reader within the 902-928 MHz range.
Describes the reader's input/output interfaces and provides a pin assignment diagram for connectors.
Provides guidance on factors affecting read distance and how to measure it accurately.
Recommends conducting a site survey to identify and avoid potential sources of interference before installation.
Outlines best practices for reader installation, including environmental factors and power supply considerations.
Discusses the reader's uni-directional antenna and the recommended aiming for optimal performance.
Specifies requirements for reader wiring, including cable gauge and shielding for reliable operation.
Presents wiring diagrams for the reader's interfaces, including RS-232 and RFID engine connections.
Emphasizes the criticality of proper grounding for the reader's operation and safety.
Lists the components included with the Sentinel-Sense MPR-2010AR reader for installation.
Guides users on familiarizing with connectors and performing bench-top verification before full installation.
Provides step-by-step instructions for securely mounting the reader and adjusting its position.
Explains how to run custom software applications or the AWID Demo Program to control the reader.
Provides notes for system integrators, software developers, and users of the demo software.
To Next Page