Axis 211 Installation Manual

Page 16 AXIS P13 Series Installation Guide
4. Check that the network cable is connected to the AXIS P1311/P1343/P1344 and then start/
restart the camera, by disconnecting and reconnecting power. If PoE is used, start/restart the
camera by disconnecting and then reconnecting the network cable.
5. Close the command prompt when you see ‘Reply from 192.168.0.125:...’ or similar.
6. In your browser, type in http://<IP address> in the Location/Address field and press Enter on
your keyboard.
Notes:
• To open a command prompt in Windows: from the Start menu, select Run... and type cmd. Click OK.
• To use the ARP command in Windows Vista, right-click the command prompt icon and select Run as
administrator.
• To use the ARP command on a Mac OS X, use the Terminal utility in Application > Utilities.

Axis 211 Specifications

General

Camera Type	Network camera
Connectivity	Wired
Image Sensor	1/4" progressive scan CMOS
Resolution	640x480 (VGA)
Operating Conditions	0 °C to 50 °C (32 °F to 122 °F)
Storage Temperature	-20 °C to 60 °C (-4 °F to 140 °F)
Lens	4.0 mm
Viewing Angle	54°
Minimum Illumination	1.5 lux
Video Compression	Motion JPEG
Frame Rate	30 fps
Network Protocols	HTTP, SMTP, FTP, DNS, DDNS, DHCP, ARP, ICMP
Ethernet	10/100