Axis 211 Installation Guide

Page 10 AXIS P13 Network Camera Series Installation Guide
5. Enter the password as set above, and click OK. If the password is lost, the camera must be reset
to the factory default settings. See page 20.
6. AXIS P1346/AXIS P1347: The capture mode must be
set the first time AXIS P1346 is accessed. Select the
desired capture mode from the drop-down list and
click OK.
Note:
The capture mode can be changed later from the prod-
uct’s web pages, but this will reset most other settings.
For more information, see the online help or User’s
Manual.
7. If required, click Yes to install AMC (AXIS Media
Control), which allows viewing of the video stream in
Internet Explorer. You will need administrator rights
on the computer to do this.
Note:
To install AMC in Windows Vista, you must run Inter-
net Explorer as administrator. Right-click the Internet
Explorer icon and select Run as administrator.
8. The Live View page of the network camera is displayed; the Setup link leads to menus that
allow you to customize the camera.
AXIS P1346
AXIS P1347
Setup – Provides all the
tools for configuring the
camera to requirements.
Help – Displays online
help on all aspects of
using the camera.

Axis 211 Specifications

General

Camera Type	Network camera
Connectivity	Wired
Image Sensor	1/4" progressive scan CMOS
Resolution	640x480 (VGA)
Operating Conditions	0 °C to 50 °C (32 °F to 122 °F)
Storage Temperature	-20 °C to 60 °C (-4 °F to 140 °F)
Lens	4.0 mm
Viewing Angle	54°
Minimum Illumination	1.5 lux
Video Compression	Motion JPEG
Frame Rate	30 fps
Network Protocols	HTTP, SMTP, FTP, DNS, DDNS, DHCP, ARP, ICMP
Ethernet	10/100