interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Using an unshielded network cable
(UTP) – -
This equipment has been
tested using an unshielded network
cable (UTP) and found to comply with
the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference when the equipment is
operated in a commercial
environment. This equipment
generates, uses, and can radiate radio
frequency energy and, if not installed
and used in accordance with the
instruction manual, may cause harmful
interference to radio communications.
Operation of this equipment in a
residential area is likely to cause
harmful interference in which case
the user will be required to correct the
interference at his own expense.
Canada - This Class B digital
apparatus complies with Canadian
ICES-003.
Europe - This digital equipment
fulfills the requirements for RF
emission according to the Class B limit
of EN 55022.
The product shall be connected using a
shielded network cable (STP) that is
properly grounded.
This product fulfills the requirements
for immunity according to EN 61000-
6-1 residential, commercial and light-
industrial environments. This product
fulfills the requirements for immunity
according to EN 61000-6-2 industrial
environments.
This product fulfills the requirements
for immunity according to EN 55024
office and commercial environments
Australia/ New Zealand - This
digital equipment fulfills the
requirements for RF emission
according to the Class B limit of
AS/NZS CISPR 22. The product shall be
connected using a shielded network
cable (STP) that is properly
grounded.
Japan
Korea
Safety
This product complies with IEC/EN/
UL 60950-1 Safety of Information
Technology Equipment.
Disposal and Recycling
This symbol means that the
product shall not be
disposed of together with
household or commercial waste.
Directive 2012/19/EU on waste
electrical and electronic
equipment (WEEE) is applicable in the
European Union member states. To
prevent potential harm to human
health and the environment, the
product must be disposed of in
an approved and environmentally safe
recycling process. For information
To Next Page
Loading...