Axon Fleet 3 - Power Off; Ready to Record; Battery Status: Full

Axon Fleet 3 Installation Guide
Axon Enterprise, Inc. Page 11 of 47
Wiring Information
This section provides an overview of the vehicle wiring layout for Axon Fleet 3. The
information should be used with the image on the following page.
• The Vehicle MDC connects to the Cradlepoint router with an Ethernet cable (yellow
line).
• The Fleet 3 Hub connects to the Cradlepoint router using an Ethernet cable (yellow
line).
• Axon Fleet 3 Cameras connect to Hub using Ethernet cables (blue line). The cameras
also receive power from the Hub through the cables.
• The Interior Antenna connects to Hub for Wi-Fi/Bluetooth to support GPS and Body-
Worn Camera connectivity (white line).
• The Power and Signal Harness provides power (red line), ignition (red line), and
signal inputs (green line) for Hub, Cradlepoint router.
• The Axon Signal Vehicle Fleet 3 cable assembly is connected to the Power and Signal
harness to extend the same inputs to the ASV.