CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
AX-ADXSVI
INSTALLATION INSTRUCTIONS
AxxessInterfaces.com © COPYRIGHT 2017 METRA ELECTRONICS CORPORATION REV. 8/28/17 INSTAX-ADXSVI
INTERFACE FEATURES
INTERFACE COMPONENTS
TOOLS REQUIRED
• Cutting tool • Crimping tool • Tape
• Connectors (example: butt-connectors, bell
caps, etc.)
AX-ADXSVI Series main interface control box
• Provides accessory (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Used in non-amplified systems or when replacing amplified systems
• Provides NAV outputs (parking brake, reverse, mute, V.S.S.)
• Prewired ASWC-1 harness included (ASWC-1 sold separately)
• Retains 3.5mm AUX jack (Ram)
• Retains back-up camera, if through the OE radio (Ram)
• High level speaker input
• USB updatable
Note:
This is a general list for the AX-ADXSVI lineup. Please see the individual harnesses for exact features available.
• AX-ADXSVI interface
APPLICATIONS
See inside front cover
To Next Page
Need help?
General
